All
materials are NSF approved and components UL listed,
meeting or exceeding all NSF and/or UL standards for safety,
quality and durability.
All
materials meet or exceed
NSF Std. 24
File No.U-8552
ANSI Z124.1
Z124.2
ASTM E 162
ASTM E 84
Also
Classified by
Underwriters
Labratory, Inc.
In Accordance with:
ASME/ANSI A112.19.7M
Water Retention Test
Requirement From
ASME/ANSI A212.12.7M
Colors will look different due to monitor and color settings. Please contact us
and request color samples to be mailed to you.
Our warm to the touch surface Gel Coats have been exclusively
made for our baths. Our lustrous colors resist fading and will
shine for years.
Warm to the Touch (not cold like porcelain)
Lustrous non porus surface
Easy to clean and maintain shine
Resists stains, scratches, impacts and burns
Most blemishes can be removed with buffing compound.
Repairs can be done easily without any visual evidence of
repair being done, unlike acrylics or porcelain which repairs
leave obvious marks where repair was made. Please contact
us before any repair is made, even if bath is past warranty
period.
After a few years your bath may appear dull due to soap build
up, hard water, etc. To restore to its original luster simply use
automotive type wax or visit local hardware store for fiberglass
wax or polish.
Our tried and true fiberglass backer and reinforcement has
withstood the test of time. It also has insulating properties far
greater than porcelain or cast metal baths. Our baths will only
allow for a few degree F. drop in temperature per 30
minutes(in normal room temperatures 64 to 78 degrees F).
