Please "click" on any of the following links for more information

Operation of your Sigma bath whirlpool system is very simple.
Always make sure bath water is at least 2" above highest jet.
To turn on whirlpool system either push the pneumatic power
button once or the "Jets" button on your Electronic Bath
controller. To turn off simply push the pneumatic power
button once again or the "Jets" button on your Electronic Bath
controller.

If your bath has the Electronic Bath Controller option it has a
twenty minute timer built into it to shut off whirlpool system.

If you have a Safety Suction Controller the power can be shut
off automatically due to blockage of water intake.

If you have Water Level Sensor your whirlpool system will not
turn on until water level reaches contact 2" above highest jet.

You may change direction of flow from the multi-directional
body jets. To adjust direction simply push nozzle to desired
direction.

To adjust amount of air turn the Air Volume Control,
turn to left to add air - turn to right to shut off air.

You may change the direction of flow from multi-directional
body jets. To adjust direction simply push nozzle to desired
direction.

You will also have a flow control knob to pass water to the back
jets, in effect allowing you to turn them on or off and control
water flow.

There are two Air Volume Controls, one for body jets and one
for back jets. To adjust strength of whirlpool current turn the
Air Volume Controls, turn to left to add air - turn to right to
shut off air.

You may change direction and control flow of multi-directional
and adjustable flow body jets.

To adjust direction simply push nozzle to desired direction to
adjust flow turn to left for more - turn to right for less.

You will also have a flow control knob to pass water to the back
jets, in effect allowing you to turn them on or off and control
water flow.

There are two Air Volume Controls, one for body jets and one
for back jets. To adjust strength of whirlpool current turn the
Air Volume Controls, turn to left to add air - turn to right to
shut off air.

The light option is turned on by either a pneumatic power
button (separate from whirlpool system power button) or the
"Option" button on the Electronic Bath Controller. To turn off
simply push the pneumatic power button once again or the
"Option" button on your Electronic Bath controller.

Your LED light option has six colors and ten lighting modes.
To switch between color and mode options simply push the
power button on and off within a few seconds, the color or
mode will change every time you turn light back on. After
your light has been off for some time before turning on, it will
stay at the last color or mode you had it set on. Again, to
change just push power button off then within 3 seconds
turn back on and continue until desired color or mode is found.

Our in-line heater option operates automatically via suction
sensor. The heater will turn on when pump/motor is turned on,
you can tell the heater is turned on by the small red light
located on top of heater. The in-line heater maintains water
temperature to 104 F.

The safety Suction Controller option also works automatically.
This option is only available along with the Electronic Bath
Controller. In the event of blockage of whirlpool system intake,
the Safety Suction Controller will automatically shut of pump.