Prior to installation read owners manual and installation
instructions and warranty.

All local and state building codes must be met when installing
your bath. Have only a licensed and insured electrician install
separate 115VAC circuit with GFCI. Sigma recommends having
licensed and insured contractor install your Sigma bath.

Your Sigma Whirlpool Bath arrives ready for installation, with
pre-leveled base, completely equipped with pump/motor
assembly and plumbing and fittings necessary for whirlpool
operation. Our whirlpool baths come with cord and standard 3
prong plug ready to connect to your GFCI. You will have to
purchase drain and overflow kit and faucet to meet your
desired location and/or finish. You may also need to purchase
tile flange kit to install bath directly against wall tile. Your local
home improvement store or plumbing house will have these
items.

Sigma baths do not get packed for shipping until thorough
inspections have been completed. Sigma baths do not leave
our facilities damaged in any way. Sigma is not responsible for
damage occurred during shipping or installation. Please inspect
your Sigma bath as soon as it arrives, first check crate for
damage and then inspect bath and water test. Please refer
to owners manual and you may also see our recommendations
on "Before installing your Sigma bath" link below.

Please "click" on any of the following links for more information